2008 Chrysler PT Cruiser Owner Manual - Page 36

34 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE Up to eight transmitters can be programmed to your vehicle. To obtain additional transmitters, contact your authorized dealer. To program a transmitter (within 23-50 ft/7-15 m of the vehicle), perform the following procedure: 1. Gather every transmitter that is to be used with the vehicle including any transmitters that are currently programmed. 2. Enter Program Mode: Turn the ignition to the ON position, and using a currently programmed transmitter; press and hold the ЉUnlockЉ button on the transmitter. Continue to hold the "Unlock" button, wait at least four but no longer than 10 seconds, then press and hold the PANIC button for at least one second. Release both buttons simultaneously. 3. Program Each Transmitter: All transmitters to be used with your vehicle must be programmed as follows: Press and release the ЉLockЉ and ЉUnlockЉ buttons simultaneously, followed by a press and release of ANY button on each transmitter to be programmed. You will hear a chime when a transmitter has been successfully programmed. GENERAL INFORMATION This transmitter complies with FCC rules part 15 and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference that may be received, including interference that may cause undesired operation. If your Remote Keyless Entry௡ fails to operate from a normal distance, check for these two conditions: 1. Weak batteries in transmitter. The expected life of batteries is from one to two years 2. Closeness to a radio transmitter such as a radio station tower, airport transmitter, and some mobile or CB radios.