2010 Chrysler 300 User Guide - Page 22

GETTING STARTED PROGRAMMABLE FEATURES Electronic Vehicle Information Center (EVIC) - If Equipped • The EVIC can be used to program the following Personal Settings. Press and release the MENU button until Personal Settings displays, then press the SCROLL button to scroll through the settings. Press the FUNCTION SELECT button to change the setting. • Language • Auto Door Locks • Auto UNLK On Exit • RKE Unlock • RKE Linked To Memory • Sound Horn With RKE Lock • Flash Lamp Lock • Headlamp Off Delay • Easy Exit Seat • Tilt MIRR. In Reverse • Turn Headlamps On With Remote Key Unlock • Key-Off Power Delay • AWD System Displays • Display ECO • Turn-by-Turn Navigation • Confirmation of Voice Commands • Park ASST. System • Display Units of Measure • Automatic High Beams • Rain Sensing Intermittent Wipers • Turn Headlamps On With Wipers • Passive Entry Key Fob Programmable Features • The following features may also be programmed by using the Key Fob transmitter or the ignition switch and driver's door lock switch. NOTE: Pressing the LOCK button while you are inside the vehicle will activate the Vehicle Security Alarm. Opening a door with the Vehicle Security Alarm activated will cause the alarm to sound. Press the UNLOCK button to deactivate the Vehicle Security Alarm. Unlock On First Press • To unlock either the driver's side, or all doors, on the first press of the UNLOCK button: • Press and hold the LOCK button for at least 4 seconds, but no longer than 10 seconds. Then, press and hold the UNLOCK button while still holding the LOCK button. • Release both buttons at the same time. Auto Unlock Doors On Exit • To have all of the vehicle doors unlock when any door is opened: • Enter your vehicle and close all the doors. • Within 15 seconds, cycle the ignition switch between LOCK and ON and then back to LOCK four times, ending up in the LOCK position (do not start the engine). • Within 30 seconds, press the power door UNLOCK switch to unlock the doors. A single chime will indicate that programming is complete. 20