2013 Chrysler 200 User Guide - Page 10

G E T T I N G S TA R T E D KEY FOB Locking And Unlocking The Doors • Press and release the UNLOCK button on the RKE transmitter once to unlock the driver's door (EVIC can be setup for driver door first, otherwise this will unlock all doors), or press the unlock button twice within five seconds to unlock all doors. The turn signal lights will flash to acknowledge the unlock signal. The illuminated entry system will also turn on. • All doors can be programmed to unlock on the first press of the UNLOCK button. Refer to Programmable Features in this guide. Opening The Trunk • Press the TRUNK button on the transmitter two times within five seconds to open the trunk. Panic Alarm • Press the PANIC button once to turn the panic alarm on. • Wait approximately three seconds and press the button a second time to turn the panic alarm off. WARNING! • • When leaving the vehicle, always remove the key fob from the ignition and lock your vehicle. Never leave children alone in a vehicle, or with access to an unlocked vehicle. Allowing children to be in a vehicle unattended is dangerous for a number of reasons. A child or others could be seriously or fatally injured. Children should be warned not to touch the parking brake, brake pedal or the shift lever. Do not leave the key fob in the vehicle, or in a location accessible to children. A child could operate power windows, other controls, or move the vehicle. • REMOTE START • Press the REMOTE START button 2 on the Key Fob twice within five seconds. Pressing the REMOTE START button a third time shuts the engine off. x • To drive the vehicle, press the UNLOCK button, insert the key in the ignition and turn to the ON/RUN position. • With remote start, the engine will only run for 15 minutes (timeout) unless the ignition key is placed in the ON/RUN position. • The vehicle must be started with the key after two consecutive timeouts. 8