2007 Dodge Charger Owner's Manual - Page 113
2007 Dodge Charger Manual
Page 113 highlights
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 113 NOTE: If programming a garage door opener or gate operator, it is advised to unplug the device during the cycling process to prevent possible overheating. 3. Continue to press and hold the HomeLink button while you press and release your hand-held transmitter every two seconds until the frequency signal is accepted successfully by HomeLink. The EVIC will display "Channel X Trained" (where X is Channel 1, 2, or 3). Proceed with Programming Step 4 to complete the procedure. Using HomeLink To operate, simply press and release the programmed HomeLink button. Activation will now occur for the trained device (i.e. garage door opener, gate operator, security system, entry door lock, home/office lighting, etc.). For convenience, the hand-held transmitter of the device may also be used at any time. In the event that there are still programming difficulties or questions, contact HomeLink at www.homelink.com or 1-800-3553515. Erasing HomeLink Buttons To erase programming from the three buttons (individual buttons cannot be erased but can be reprogrammed note below), follow the step noted: • Press and hold the two outer HomeLink buttons. Release the buttons only when the EVIC displays "Channels Cleared" (after 20 seconds); however, do not hold the buttons for longer than 30 seconds. HomeLink is now in the train (or learning) mode and can be programmed at any time beginning with Programming Step 2. Reprogramming a Single HomeLink Button To program a device a previously trained HomeLink button, follow these steps: 1. Press and hold the desired HomeLink button. Do NOT release the button. 2. The EVIC will display "Channel X Transmit" (where X is Channel 1, 2, or 3) for 20 seconds and then change to "Channel X Training." Without releasing the HomeLink button, proceed with Programming Step 2. 3