2007 Dodge Durango Owner's Manual - Page 165

NOTE:

If programming a garage door opener or gate

operator, it is advised to unplug the device during the

²

cycling

²

process to prevent possible overheating.

Using HomeLink

To operate, simply press and release the programmed

HomeLink button. Activation will now occur for the

trained device (i.e. garage door opener, gate operator,

security system, entry door lock, home/office lighting,

etc.). For convenience, the hand-held transmitter of the

device may also be used at any time. In the event that

there are still programming difficulties or questions,

contact HomeLink at:

www.homelink.com or 1-800-355-

3515

.

Erasing HomeLink Buttons

To erase programming from the three buttons (individual

buttons cannot be erased but can be

²

reprogrammed

²

-

note below), follow the step noted:

•

Press and hold the two outer HomeLink buttons, and

the EVIC will display “CLEARING CHANNELS”, do

not

release

the

buttons

until

“CHANNELS

CLEARED” is displayed on the EVIC (after approxi-

mately 20 seconds). Release both buttons. Do not hold

for longer that 30 seconds. HomeLink is now in the

train (or learning) mode and can be programmed at

any time beginning with

²

Programming

²

- step 2.

Reprogramming a Single HomeLink Button

To program a device to HomeLink using a HomeLink

button previously trained, follow these steps:

1. Press and hold the desired HomeLink button.

DO

NOT

release the button.

2. The EVIC will display “CHANNEL X TRANSMIT” for

20 seconds and then change to “CHANNEL X TRAIN-

ING”. Without releasing the HomeLink button, proceed

with

²

Programming

²

step 2

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

165

3

2007 Dodge Durango Owner's Manual - Page 165

2007 Dodge Durango Manual

Page 165 highlights