2008 Dodge Viper Owner Manual Supplement - Page 21
2008 Dodge Viper Manual
Page 21 highlights
5.7 Notes on Tuning Damper Adjustment Adjusting from the street settings should be done only at track events. A recommended starting position for the tracks is: Front: Compression = Position "6" Rebound = Position "6" Rear: Compression = Position "5" Rebound = Position "5 Always start from a known position (full stiff). Adjust in small increments (1-2 clicks) Record your adjustment settings at all four wheels Continually monitor and record your tire pressures Maintenance and Inspection Regularly inspect the splitter rub strips and out board knock-in nut. Regularly inspect all attachments of the aerodynamic components (see Aerodynamics section). Track use will greatly increase wear rates and service intervals on your Viper ACR. Repeated track use requires more frequent fluid changes. Because of the extreme conditions encountered during track use, any damage or wear associated with track use is not covered by warranty (see Warranty section). NOTE: Although your vehicle is shipped with 0W40, it is recommended to use Mobil-1 15W50 synthetic motor oil at the track. Always run a cool down lap at the end of a track outing. For track outings lasting longer than 25 minutes, an external rear axle cooler is recommended. Remember that suspension damping, ride heights, rake angle and aerodynamic balance all work as a system. As you make changes to one end of the vehicle, it will affect the balance of the car.