2009 Dodge Nitro Owner Manual - Page 178
2009 Dodge Nitro Manual
Page 178 highlights
176 UNDERSTANDING YOUR INSTRUMENT PANEL 7. Speedometer Shows the vehicles speed. 8. High Beam Indicator This indicator shows that the headlights are on high beam. Push the multifunction lever forward to switch the headlights to high beam, and pull toward yourself (normal position) to return to low beam. 9. Vehicle Security Light - If Equipped This light will flash at a fast rate for approximately 15 seconds, when the vehicle security alarm is arming, and then will flash slowly until the vehicle is disarmed. 10. Electronic Stability Program (ESP) Warning Light / Brake Assist System (BAS) Warning Light - If Equipped The malfunction lamp for the Electronic Stability Program (ESP) is combined with Brake Assist System (BAS). The yellow "ESP/BAS Warning Lamp" comes on when the ignition switch is turned to the "ON" position. They should go out with the engine running. If the "ESP/BAS Warning Lamp" comes on continuously with the engine running, a malfunction has been detected in either the ESP or the BAS system. If this light remains on after several ignition cycles, and the vehicle has been driven several miles at speeds greater than 30 mph (48 km/h), see an authorized dealer as soon as possible. NOTE: The ESP Control System will make buzzing or clicking sounds when it is actively operating. 11. TOW/HAUL Indicator - If Equipped The TOW/HAUL button is located on the gear shift bezel. This light will illuminate when the TOW/HAUL button has been selected. 12. Turn Signal Indicators The arrow will flash with the exterior turn signal when the turn signal lever is operated.