2012 Dodge Caliber Owner Manual - Page 166
2012 Dodge Caliber Manual
Page 166 highlights
164 UNDERSTANDING THE FEATURES OF YOUR VEHICLE To Set A Desired Speed Turn the Electronic Speed Control ON. When the vehicle has reached the desired speed, press down on the Electronic Speed Control lever and release. Release the accelerator and the vehicle will operate at the selected speed. To Resume Speed To resume a previously set speed, push the RESUME ACCEL lever up and release. Resume can be used at any speed above 20 mph (32 km/h). To Vary The Speed Setting NOTE: The vehicle should be traveling at a steady When the Electronic Speed Control is set, you can inspeed and on level ground before pressing the SET lever. crease speed by pushing up and holding the RESUME ACCEL lever. If the lever is continually held in the To Deactivate RESUME ACCEL position, the set speed will continue to A soft tap on the brake pedal, pulling the Electronic increase until the lever is released, then the new set speed Speed Control lever toward you CANCEL, normal brakwill be established. ing or pressing the clutch pedal while slowing the vehicle will deactivate Electronic Speed Control without erasing Tapping the RESUME ACCEL lever once will result in a the set speed memory. Pressing the ON/OFF button or 1 mph (2 km/h) increase in set speed. Each subsequent turning the ignition switch OFF erases the set speed tap of the lever results in an increase of 1 mph (2 km/h). memory. To decrease speed while the Electronic Speed Control is set, push down and hold the SET DECEL lever. If the lever is continually held in the SET DECEL position, the set speed will continue to decrease until the lever is