2014 Dodge Grand Caravan Passenger Owner Manual - Page 559

WHAT TO DO IN EMERGENCIES 557 NOTE: Sealant may leak out through the puncture in the NOTE: If the Mode Select Knob (5) is on Air Mode and tire. the pump is operating, air will dispense from the Air Pump Hose (7) only, not the Sealant Hose (6). If the sealant (white fluid) does not flow within 0 - 10 seconds through the Sealant Hose (6): If the sealant (white fluid) does flow through the Sealant Hose (6): 1. Press the Power Button (4) to turn Off the TIREFIT kit. Disconnect the Sealant Hose (6) from the valve stem. 1. Continue to operate the pump until sealant is no Make sure the valve stem is free of debris. Reconnect longer flowing through hose (typically takes 30 - 70 the Sealant Hose (6) to the valve stem. Check that the seconds). As the sealant flows through the Sealant Mode Select Knob (5) is in the Sealant Mode position Hose (6), the Pressure Gauge (3) can read as high as 70 and not Air Mode. Press the Power Button (4) to turn psi (5 Bar). The Pressure Gauge (3) will decrease On the TIREFIT kit. quickly from approximately 70 psi (5 Bar) to the actual tire pressure when the Sealant Bottle (1) is empty. 2. Connect the Power Plug (8) to a different 12 Volt power outlet in your vehicle or another vehicle, if 2. The pump will start to inject air into the tire immediavailable. Make sure the engine is running before ately after the Sealant Bottle (1) is empty. Continue to turning ON the TIREFIT kit. operate the pump and inflate the tire to the pressure indicated on the tire pressure label on the driver-side 3. The Sealant Bottle (1) may be empty due to previous latch pillar (recommended pressure). Check the tire use. Call for assistance. pressure by looking at the Pressure Gauge (3). 6