1999 Ford F150 Owner Guide 1st Printing - Page 217

Capacities and specifications Fill to 6-14 mm (1/4-9/16 inch) below bottom of filler hole. 4 Ensure the correct automatic transmission fluid is used for a specific application. Check the container to verify the fluid is MERCON௡ approved. Transmission fluid requirements are indicated on the dipstick handle. Refer to the Scheduled Maintenance Guide. Do NOT use any non-approved automatic transmission fluid for an application specifying MERCON௡. Use of a non-approved fluid may cause internal transmission component damage. 5 Indicates only approximate dry-fill capacity. Some applications may vary based on cooler size and if equipped with an in-tank cooler. The amount of transmission fluid and fluid level should be set by the indication on the dipstick's normal operating range. 6 Add 118 ml (4 oz.) of additive friction modifier C8AZ-19B546-A, Ford specification EST-M2C118-A, for complete fill of 8.8 inch and 9.75 inch Traction-Lok axles. 7 Add 236 ml (8 oz.) of additive Friction Modifier C8AZ-19B546-A, Ford Specification EST-M2C118-A, for complete fill of 10.25 inch Traction-Lok axles. 8 In-vehicle refill: approximately 3.1L (6.5 pints). LUBRICANT SPECIFICATIONS Item Front axle (4X4) Ford part name or equivalent Motorcraft SAE 75W90 Axle Lubricant Motorcraft SAE 75W140 High Performance Synthetic Rear Axle Lube1 High Performance DOT 3 Motor Vehicle Brake Fluid Ford part number XY-75W90-QL F1TZ-19580-B Ford specification WSP-M2C201-A WSL-M2C192-A Rear axle C6AZ-19542-AB Brake fluid and clutch fluid ESA-M6C25-A and DOT 3 217