2000 Ford Excursion Owner's Manual - Page 62

Controls and features Compass calibration adjustment Perform this adjustment in an open area free from steel structures and high voltage lines. For optimum calibration, turn off all electrical accessories (heater/air conditioning, wipers, etc.) and make sure all vehicle doors are shut. 1. Locate the trip computer located in the overhead console. 2. Start the vehicle. 3. Press and hold both trip computer controls. After approximately eight seconds, the trip computer will enter CAL mode. E/M MODE CAL mode is indicated when the display lights the "CAL" indicator. RESET 4. Release both controls. The display will return to normal, except that the CAL indicator will remain lit until the compass is sucessfully calibrated. 5. Slowly drive the vehicle in a circle (less than 5 km/h [3 mph]) until the CAL indicator turns off. It may take up to five circles to complete calibration. 6. The compass is now calibrated. INTERIOR LAMPS Dome/Map lamps (if equipped) The map lamps and controls are located on the dome lamp. Press the controls on either side of each map lamp to activate the lamps. 62