2004 Ford F150 Owner Guide 5th Printing - Page 87
2004 Ford F150 Manual
Page 87 highlights
Locks and Security The (lock) and (unlock) features will work again after: • a door has become ajar, • the ignition is turned to the 3 (ON) position, or control on your remote entry transmitter or • using the UNLOCK unlocking via the keyless entry keypad. Deactivating/activating power door lock/unlock disable feature All vehicle doors must be closed before beginning the procedure. You must complete Steps 1-5 within 30 seconds, or the procedure will have to be repeated. If the procedure needs to be repeated, you must wait a minimum of 30 seconds to begin again. 1. Turn the ignition to the 3 (ON) position, then press the three times. button 2. Turn the ignition to the 1 (OFF/LOCK) position, then press the button three times. 3. Turn the ignition to the 3 (ON) position, and within five seconds, button two times. Note: After turning the ignition to the 3 press the (ON) position, two horn chirps should be heard, indicating that the system has been disabled. Conversely, two horn chirps followed by a honk will indicate that the system is enabled. button two times again will turn the 4. Pressing the power door feature ON if it was previously OFF, or OFF if it was previously ON. button after successfully Every two consecutive presses of the entering the configuration mode will change the enable/disable condition of the feature. 5. Turn the ignition to the 1 (OFF/LOCK) position to exit programming. Note: After exiting the driver configuration mode, the horn will chirp once to indicate a feature has been activated/deactivated. Sounding a panic alarm to activate the alarm. Press again or turn the ignition to 2 Press (ACCESSORY) or 3 (ON) to deactivate. Note: The panic alarm will only operate when the ignition is in the 1 (OFF/LOCK) position. 87 2004 F150 (f12) Owners Guide (post-2002-fmt) USA English (fus)