2007 Ford Crown Victoria Owner's Manual - Page 89
2007 Ford Crown Victoria Manual
Page 89 highlights
Locks and Security • Perform the following programming procedure yourself: Note: Ensure the brake pedal is not 3 depressed during this sequence. Place the key in the ignition and 2 cycle from 1 (OFF/LOCK) to 3 (ON) 4 eight times in rapid succession within 10 seconds. After doors lock/unlock, press any control on all transmitters (up to four). After 1 pressing the control on each remote transmitter, the door will lock and unlock. If programming multiple remote transmitters, you must press the control buttons on each remote transmitter within 7 seconds of each other to remain in programming mode. When completed, turn the ignition to 1 (OFF/LOCK). All transmitters must be programmed at the same time. • When completed, turn the ignition to the 1 (OFF/LOCK) position and wait at least 20 seconds in order to use the recently programmed transmitter(s). • All transmitters must be programmed during the same programming cycle. A transmitter that is not programmed within the same programming cycle will be erased and will no longer operate your vehicle's locks. If this occurs, you will have to reprogram all the transmitters again, as you cannot just "add" a transmitter. Illuminated entry The interior lamps illuminate when the remote entry system is used to unlock the door(s) or sound the personal alarm. The illuminated entry system will turn off the interior lights if: • the ignition switch is turned to the 2 (ACCESSORY), 3 (ON) or 4 (START) positions, or • the remote transmitter lock control is pressed, or • after 25 seconds of illumination. The dome lamp control must not be set to the off position for the illuminated entry system to operate. 89 2007 Crown Victoria (cro) Owners Guide (post-2002-fmt) USA (fus)