2007 Ford Explorer Sport Trac Owner Guide 4th Printing - Page 94

Driver Controls Press and release the control to open window to the vent position. control Press and release the again to open window to the full open position. control to Press and release the close the window all the way to the full closed position. Normal Operation When the power down back window is opened, it will stop in the vent position. When the window is closed from full open, it will not stop in the vent position. When the power down back window is in motion, the control switch can be pressed to change the window direction and move it to the closest position. If the power down back window is moving up and the ignition is switched to OFF (without accessory delay power enabled) the window will reverse direction and move down to either the full open or vent position. If the window is within 0.16 in. (4 mm) of the upper header, it will completely close. Bounce-Back When the back window is moving upward and an obstacle interferes with the window's movement, the back window will reverse direction and move toward the fully open position. This is known as "bounce-back". Security Override If, during a bounce-back condition and within 2 seconds after the direction, the back window window stops, the control is held in the will travel up with no bounce-back protection. If the control is released before the window reaches fully closed, the back window will continue moving up with bounce-back re-enabled. The following are possible reasons for using the security override: • Ice on the window causing a restriction. • Window unexpectedly reverses. Position recovery mode If the motor loses position and stops mid travel, the motor will respond to switch inputs by moving 0.6 in. (15 mm) each switch command in the 94 2007 07+ Explorer Sport Trac (esp) Owners Guide (post-2002-fmt) USA (fus)