2008 Ford Edge Scheduled Maintenance Guide 3rd Printing - Page 25
2008 Ford Edge Manual
Page 25 highlights
NORMAL SCHEDULE TRUCKS, FULLSIZE VANS & SUVS 120,000 miles Change engine oil and replace oil filter Replace cabin air filter (if equipped) Replace climate-controlled seat filter (if equipped) Replace engine air filter Replace fuel filter Replace PCV valve on all light trucks over 6,000 lbs. Gross Vehicle Weight (GVW) (except 3V engines) Change automatic transmission fluid on all vehicles equipped with the TorqShift transmission. Replace the externally-mounted remote filter element for all TorqShift transmissions (if equipped). Replace the internal TorqShift transmission fluid filter located inside the transmission bottom pan (vehicles without externally-mounted remote filter only). Inspect automatic transmission/transaxle fluid level on all other vehicles if equipped with dipstick. Consult your dealer for particular requirements. Replace wheel bearing grease and grease seals on 4x2 wheel bearings (if non-sealed bearings) Inspect steering linkage, suspension and, if equipped, driveshaft, ball joints and U-joints Inspect engine cooling system and hoses Inspect brake pads, shoes, rotors, drums, brake lines and hoses and parking brake system. Inspect half shaft boots (if equipped) Inspect exhaust system and heat shields Inspect drive belts Inspect automatic transmission fluid level (if equipped with an underhood dipstick) Lubricate ball joints and U-joints (if equipped with zerk fittings) Inspect and lubricate 4x4 front axle U-joints Perform multi-point inspection (recommended) Rotate tires, inspect tires for wear and measure tread depth (vehicles with dual rear wheels should only rotate if unusual wear is noted) Inspect wheels for end play and noise DEALER VALIDATION: Normal Schedule Trucks, Fullsize Vans & SUVs RO#: DATE: P&A CODE: MILEAGE: Scheduled Maintenance 25 2008 (smg) Scheduled Maintenance Guide USA (fus)