2008 Ford Ranger Owner Guide 2nd Printing - Page 68
2008 Ford Ranger Manual
Page 68 highlights
Locks and Security • If no previously programmed coded keys are available, you must take your vehicle to your authorized dealer to have the spare key(s) programmed. 1. Insert a previously programmed coded key into the ignition. 4 2. Turn the ignition from the 3 3 (OFF) position to the 4 (ON) 5 position. Keep the ignition in the 4 (ON) position for at least one 2 second, but no more than 10 seconds. 1 3. Turn the ignition to the 3 (OFF) position, and remove the coded key from the ignition. 4. Within ten seconds of removing the previously programmed coded key, insert the other previously programmed coded key into the ignition. 5. Turn the ignition from the 3 (OFF) position to the 4 (ON) position. Keep the ignition in the 4 (ON) position for at least one second but not more than 10 seconds. 6. Turn the ignition to the 3 (OFF) position, and remove the second key from the ignition. 7. Within twenty seconds of removing the previously programmed coded key, insert the unprogrammed key (new/valet key) into the ignition. 8. Turn the ignition from the 3 (OFF) position to the 4 (ON) position. Keep the ignition in the 4 (ON) position for at least one second. 9. Your new unprogrammed key is now programmed. If the key has been successfully programmed it will start the vehicle's engine and the theft indicator light will illuminate for three seconds and then go out. If the key was not successfully programmed, it will not start your vehicle's engine and the theft indicator light will flash on and off rapidly. If failure repeats, bring your vehicle to your authorized dealer to have the new key(s) programmed. To program additional new unprogrammed key(s), repeat this procedure from Step 1 for each additional key. 68 2008 Ranger (ran) Owners Guide (post-2002-fmt) USA (fus)