2009 Ford Crown Victoria Owner's Manual - Page 51

Lights 1. Make sure the headlamp switch is in the off position, then open the trunk and remove the pin-type retainer. 2. Carefully pull the carpet away to expose the lamp assembly hardware. 3. Remove three nuts and the lamp assembly from the vehicle. 4. Remove the bulb socket by rotating it counterclockwise, then pulling it out of the lamp assembly. 5. Pull the bulb from the socket and push in the new bulb. 6. Install the bulb socket into the lamp assembly by rotating it clockwise. 7. Install the lamp assembly on the vehicle with three nuts ensuring the nuts are flush with the body to prevent water from entering the trunk. 8. Carefully push the carpet back in to place and install the pin-type retainer. Replacing license plate lamp bulbs 1. Make sure headlamp switch is in the off position, then remove two screws, grommets and the license plate lamp assembly from the trunk lid. 2. Carefully pull the bulb from the socket and push in the new bulb. 51 2009 Crown Victoria (cro) Owners Guide, 2nd Printing USA (fus)