2009 Ford Expedition EL Owner Guide 2nd Printing - Page 133
2009 Ford Expedition EL Manual
Page 133 highlights
Driver Controls 5. Press and hold the RESET stem for approximately two seconds to enter the compass zone adjustment mode. 6. Press and release the RESET stem until the desired zone number appears. 7. Release the RESET stem and allow the setup timer to expire to exit the procedure. Compass calibration adjustment NOTE: For optimum calibration, drive to an open, level location away from large metallic objects or structures. Switch off all non-essential electrical accessories (heated rear window, heater, A/C, map lamps, wiper, etc.) and make sure all the doors are closed. 1. Start the vehicle. Press and release the RESET stem to scroll through the information displays until the message center displays HOLD RESET FOR SETUP MENU. 2. Press and hold the RESET stem for approximately two seconds until the message center displays HOLD RESET FOR SYSTEM CHECK. 3. Press and release the RESET stem to scroll through the system check displays until the message center displays COMPASS ZONE . 4. Press and hold the RESET stem for approximately two seconds until the message center to enter the compass zone adjustment mode. 5. Press and hold the RESET stem until the message center displays CIRCLE SLOWLY TO CALIBRATE. NOTE: This step may require up to five circles to complete the calibration. NOTE: If the RESET stem is pressed during the calibration or three minutes has elapsed since the beginning of the calibration without driving the vehicle, the message center reverts back to normal operation and the CAL will display until a successful calibration is carried out. 6. Slowly drive the vehicle in a circle less than 3 mph (5 km/h ) until the CIRCLE SLOWLY TO CALIBRATE message changes to CALIBRATION COMPLETED. Blank display Press the RESET stem once to turn the message center display off. 133 2009 Expedition (exd) Owners Guide, 2nd Printing USA (fus)