2009 Ford F350 Super Duty Regular Cab Diesel Hang Tag 1st Printing - Page 4

Recommended for use in all diesel Recommended for use in all diesel vehicles and engines vehicles and engines power" light will illuminate in the instrument cluster. Take your vehicle to your authorized Ford dealer for service. If the vehicle is brought to an idle during the regeneration process, the operator may notice an increase in engine idle speed and engine tone. This is normal and due to the DPF being cleaned. After about five minutes of continuous idle, the regeneration process will be discontinued and there may be a noticeable change in engine sound. LOW SULFUR LOW SULFUR sulfur fuels HIGHWAY DIESEL FUEL HIGHWAY DIESEL FUEL WARNING WARNING Federal law prohibits use in model Federal law prohibits use in model year 2007 and later highway year 2007 and later highway vehicles and engines. vehicles and engines. Its use may damage these vehicles Its use may damage these vehicles and engines. and engines. These higher malfunction of emissions-related components and significant damage to the engine may occur. The use of NON-HIGHWAY NON-HIGHWAY DIESEL biodiesel is FUEL DIESEL FUEL (May Exceed 500 ppm Sulfur) (May Exceed 500 ppm Sulfur) acceptable as WARNING long as the WARNING Federal law prohibits use in Federal law prohibits use in highway vehicles or engines. highway vehicles or engines. rating does not Its use may damage these vehicles Its use may damage these vehicles and engines. and engines. exceed 5% (B5). Any percentage of biodiesel requires you to maintain your vehicle using the Severe Duty maintenance schedule (e.g., oil change every 5,000 miles). Use the recommended CJ-4 engine oil in your 6.4L Power Stroke®®® engine. This engine oil has been designed to operate properly with the new emissions standards. If your vehicle is operated at high speeds while fully loaded, let the engine idle three to five minutes before shutting it off. This will allow the turbochargers to cool sufficiently and prevent the engine from overheating. (500 ppm Sulfur Maximum) will lead to the (500 ppm Sulfur Maximum) A winter grille cover is now available as a Production option for Canadian customers and select cold weather U.S. states. The grille cover is also available at authorized Ford dealers for customers to purchase. The cover can be installed by the customer when heavy snow conditions exist. It must be removed at temperatures above 50˚F (10˚C) or above 32˚F (0˚C) when towing a trailer. Using the engine block heater during cold weather is very important to ensure proper starting of the vehicle and adequate lubrication during start-up. This will prevent cold weather start-up engine damage. A block heater must be used when temperatures are below -10˚F (-23˚C.) For conditions when the coolant temperature is below -10˚F (-23˚C), the message center will display a 30 second countdown timer. During this time, the engine will be limited to idle for a period of 30 seconds from engine start before normal operation can be continued. After this time has elapsed, a message "OK to Drive" will be displayed for five seconds. These messages are NORMAL. You may experience several conditions in which the engine idle speed will be elevated above the base operating range. Conditions such as low battery voltage, PTO operation and cold engine warm-up will elevate the engine idle speed. All of these conditions noted above are NORMAL and do not require the vehicle to be taken to the dealership for diagnostic testing or service. ULTRA-LOW SULFUR HIGHWAY DIESEL FUEL (15 ppm Sulfur Maximum) Required for use in all model year 2007 and later highway diesel vehicles and engines Recommended for use in all diesel vehicles and engines Ultra-Low Sulfur Diesel Fuel (ULSD) -- Your Power Stroke®® ® requires ultra low sulfur diesel fuel (15 ppm maximum). Do not use any other fuels. Do NOT use Low Sulfur Diesel Fuel (500 ppm maximum) or non-highway diesel fuel (agricultural diesel) higher than 500 ppm.