2009 Ford Flex Owner's Manual - Page 141
2009 Ford Flex Manual
Page 141 highlights
Locks and Security 2. Press doors. and release again within three seconds to unlock all the The remote entry system activates the illuminated entry feature; this feature turns on the lamps for 25 seconds or until the ignition is turned to the on position. The inside lights will not turn off if: • they have been turned on using the dimmer control or • any door is open. The battery saver feature will turn off the interior lamps 10 minutes after the ignition is turned to the off position. Two stage unlocking may be disabled or re-enabled by simultaneously and controls on the IKT for four seconds (disabling pressing the two stage unlock allows all vehicle doors to unlock simultaneously). The turn lamps will flash twice to indicate that two-stage unlock was enabled or disabled. Locking the doors 1. Press and release to lock all the doors. The turn lamps will flash. and release again within three seconds to confirm that all 2. Press the doors are closed. Note: The doors will lock again, the horn will chirp and the turn lamps will flash once if all the doors and liftgate are closed. Note: If any door or the liftgate is not closed, the horn will chirp twice and the lamps will not flash. Opening the power liftgate (if equipped) Press liftgate. twice within three seconds to fully unlatch and open the WARNING: Make sure all persons are clear of the liftgate area before using power liftgate control. In order to fully lower and latch the liftgate, press the control twice. If the liftgate stops mid travel, it may have detected an obstacle, Check to ensure the liftgate swing zone is free from obstruction and reset the power assist by manually closing the liftgate. Normal operation can then be resumed. 141 2009 Flex (471) Owners Guide, 2nd Printing USA (fus)