2009 Ford Mustang Owner Guide 1st Printing - Page 215
2009 Ford Mustang Manual
Page 215 highlights
Roadside Emergencies 8. Inflate the tire to the pressure listed on the tire label located on the driver's door or the door jam area. Note: When the sealing compound is first added into the tire, the air pressure gauge reading on the compressor unit may indicate a higher value; this is normal and should be no reason for concern. The pressure will drop after about 30 seconds of operation. The tire pressure has to be checked with the compressor in the OFF position to get the correct tire pressure reading. WARNING: Do not stand directly over the temporary mobility kit while inflating the tire. If you notice any unusual bulges or deformations in the tire's sidewall during inflation, stop and call roadside assistance. WARNING: If the tire doesn't inflate to the recommended tire pressure within 15 minutes, stop and call roadside assistance. 9. When the recommended tire pressure is reached, turn off the kit by pressing down on control button (2); disconnect the kit from the tire valve and the power point. Re-install the valve cap on the tire valve, place the tube cap on the metal connector, and return the kit to the stowage area. 10. Immediately and cautiously, drive the vehicle 4 miles (6 km) to distribute the sealant evenly inside the tire. Do not exceed 50 mph (80 km/h). Note: If you experience any unusual vibration, ride disturbance or noise while driving, reduce your speed until you can safely pull off to the side of the road to call for roadside assistance. Do not proceed to the second stage of this operation. 11. After 4 miles (6 km), stop and check the tire pressure. See Second stage: Checking tire pressure. 215 2009 05+ Mustang (197) Owners Guide USA (fus)