2010 Ford Explorer Sport Trac Owner Guide 1st Printing - Page 25
2010 Ford Explorer Sport Trac Manual
Page 25 highlights
Instrument Cluster degrees between adjacent zones and will become noticeable as the vehicle crosses multiple zones. A correct zone setting will eliminate this error. Do the following to set the proper zone: Compass zone adjustment (if equipped) 1. Determine which magnetic zone you are in for your geographic location by referring to the zone 3 2 map. 4 2. Turn ignition to the on position. 5 1 15 14 13 12 6 7 8 9 1011 3. Press and hold the SELECT/RESET stem to scroll through the information displays until the message center displays HOLD RESET FOR SETUP MENU. 4. Press and hold the SELECT/RESET stem until the message center displays HOLD RESET FOR SYSTEM CHECK. Do not hold the stem down at this point as you do not want to enter the system check. Instead, quickly release the stem and repeatedly press it again to scroll through the setup menu until the message center displays COMPASS ZONE XX. 5. Press and hold the SELECT/RESET stem for approximately two seconds to enter the compass zone adjustment mode. 6. Press and release the SELECT/RESET stem until the desired zone number appears. 7. Release the SELECT/RESET stem and allow the setup timer to expire to exit the procedure. Compass calibration adjustment Perform compass calibration in an open area free from steel structures and high voltage lines. For optimum calibration, turn off all electrical accessories (heater/air conditioning, wipers, etc.) and make sure all vehicle doors are shut. 1. Start the vehicle. 2. Press and release the SELECT/RESET stem to scroll through the information displays until the message center displays HOLD RESET FOR SETUP MENU. 25 2010 07+ Explorer Sport Trac (esp) Owners Guide (own2002), 1st Printing USA (fus)