2010 Ford Explorer Quick Reference Guide 2nd Printing - Page 2
2010 Ford Explorer Manual
Page 2 highlights
2010 EXPLORER instrument panel Use extreme caution when using any device or feature that may take your attention off the road. Your primary responsibility is the safe operation of the vehicle. Only use non-essential features and devices when it is safe to do so. 2010 EXPLORER 1. Headlamp Control O: Turns the headlamps off. :T urns on parking, instrument panel, license plate and tail lamps. :T urns on headlamps. :A utolamps (if equipped) Automatically turns the exterior lamps on/off based on available daylight. :T urns on fog lamps by pulling the control towards you. Panel dimmer control Move to adjust the level of brightness on the instrument panel when the exterior lights are on. Move to the full right position to turn on the interior lamps. Move to the left position to turn off the lights. 2. Parking Brake Release Pull the lever to release the parking brake. Driving with the parking brake engaged will cause the brakes to wear out prematurely and reduce fuel economy. 3. Multi-function Lever Rotate the end of the control up/down to increase/decrease the speed of the wipers. Push the end of the stalk: • quickly for a single swipe without fluid. • and hold briefly for three swipes with washer fluid. • and hold for a longer wash cycle. To operate your rear window wiper, turn the rear wiper control to 1 (intermittent speed), 2 (normal speed) or O (off). For a rear wash cycle, rotate and hold the rear wiper control to either position. For better visibility, your headlamps will turn on (during daylight) if your windshield wipers and autolamps (if equipped) are on. Note: For optimal wiper performance, clean your blades and glass regularly. Refer to your Owner's Guide for more information. 4. Speed Control To set the speed: 1. Press ON. 2. Accelerate to the desired speed. 3. Press SET + or and take your foot off the accelerator. • To set a higher speed, press and hold SET + or press SET + repeatedly until the desired speed is reached. • To set a lower speed, press and hold SET - or press SET - repeatedly until the desired speed is reached. To return to a previously • set speed, press RES. • To turn off, press the brake pedal or press OFF. 5. Airbag Readiness Light Illuminates briefly when the ignition is turned on. If this light fails to illuminate, remains on or continues to flash after the engine is started, contact your authorized dealer for service as soon as possible. A chime will also sound if there is a malfunction in the indicator light. 6. Service Engine Soon Light The Service Engine soon light illuminates briefly when the ignition is turned on. If it remains on or is blinking after the engine is started, the On Board Diagnostics System (OBD-II) has detected a malfunction. Drive in a moderate fashion and have your vehicle serviced immediately by an authorized dealer. 7. Hazard Flasher Control The hazard flasher is located on the steering column, just behind the steering wheel. Press to activate all front and rear direction signals. Press again to deactivate. 8. Message Center (if equipped) The message center displays important vehicle information through a constant monitoring of vehicle systems. The system will also notify you of potential vehicle problems with a display of system warnings followed by a long indicator chime. 9. Low Tire Pressure Warning light Illuminates when your tire pressure is low. If the light remains on, the tire pressure should be checked. If the light does not turn on at ignition or begins to flash, contact your authorized dealer as soon as possible. 10. ABS Warning Light illuminates The ABS light briefly when the ignition is turned on. If the ABS light remains on or continues to flash, a malfunction has been detected. Contact your authorized dealer as soon as possible. Normal braking (less ABS) is still functional unless the brake warning is also illuminated. light 11. Steering Wheel Controls VOL +/- : P ress to increase/decrease volume levels. : Press to access the previous/next radio station, CD track or preset satellite radio channel. MEDIA: Press repeatedly to access all possible media sources. VOICE: Press to access voice recognition, if equipped. : Press to access SYNC® phone features, if equipped. 12. Navigation System (if equipped) The mobile media navigation system allows you to record CDs, list to your saved music and play DVDs in addition to navigating the vehicle. For more information, refer to your Navigation supplement (if equipped). 13. Power Adjustable Pedals (if equipped) Press the bottom of the control q to move the pedals closer to you or the top of the control p to move the pedals further away from you. The pedals should only be adjusted when the vehicle is stopped and in Park (P). 14. AdvanceTrac® with Roll Stability Control™ (RSC®) Stability Enhancement system The AdvanceTrac® stability system helps you to maintain stability and steerability of your vehicle during a variety of road conditions. If your vehicle becomes stuck in the snow, mud or sand, try turning off the AdvanceTrac® system to allow wheel spin and help increase momentum to dig the vehicle out. The system defaults to on and the control will illuminate when turned off. 15. Overdrive Control Drive with the vehicle in Overdrive (D) for the best fuel economy. You can deactivate overdrive by pressing the transmission control switch on the side of the shift handle. Use this during heavy city traffic where you are continuously shifting in and out of overdrive, hilly terrain, heavy loads, trailer towing and when engine breaking is required. To return to overdrive, simply press the transmission control switch again. 16. Heated Seats (if equipped) Your vehicle may be equipped with heated seats. Press to activate/deactivate. 17. Four-Wheel Drive (4WD, if equipped) When 4X4 AUTO is selected, power is automatically provided to all four wheels. It is used for normal street and highway driving. 4X4 HIGH is used for extra traction in slippery conditions, such as in snow, on icy roads, or in off-road situations. It should not be operated on dry pavement. 4X4 LOW can be selected to provide extra gearing to deliver maximum power to all four wheels. It is intended only for off-road applications such as deep sand, steep grades or pulling heavy objects. SYNC® (if equipped) SYNC® is a hands-free communications and entertainment system with special phone and media features. For more information, please refer to the SYNC® Supplement or to the SYNC® section in the Navigation Supplement. Please also feel free to visit www.SyncMyRide.com. All Wheel Drive (AWD) (if equipped) The AWD system is always active and uses all four wheels to power the vehicle, thereby increasing traction and enabling you to drive over terrain and road conditions that a conventional two-wheel drive vehicle cannot. The system is capable of handling many different road conditions, including street and highway driving as well as off-road conditions such as deep snow, ice or shallow sand. Note: If your vehicle is equipped with AWD, a spare tire of a different size (other than the tire provided) should never be used. Using a different size could cause the AWD system to stop functioning and default to front wheel drive. Refer to your Owner's Guide for more information. DUAL AUTOmatic TEMPERATURE control (if equipped) A B C D E F G H A A. Driver/Passenger Side Temperature Control: Press to increase or decrease the temperature on the driver or passenger side of the vehicle. Pressing the passenger side control will activate dual zone where the driver and passenger are able to select their own individual settings. If the passenger side controls are not activated, the driver side controls will determine the temperature setting for the entire vehicle (single zone). B. AUTO: Press to engage full automatic operation. The system will automatically determine fan speed, airflow distribution, A/C on or off and either outside or recirculated air to heat or cool the vehicle to reach the desired temperature. C. Fan Speed: Press to increase or decrease fan speed. D. OFF: Outside air is shut out and the fan will not operate. Note: If your vehicle is equipped with the auxiliary climate control system, the auxiliary fan can still operate with the front system off. E. Manual Override Controls: Press to manually determine where airflow is directed. To return to fully automatic control, press AUTO. F. Windshield Defroster : Outside air is distributed through the windshield defroster vents. G. DUAL: Press to activate dual zone mode where the driver and passenger have control of their individual temperature settings. Press again to return to single zone where the driver's settings will determine the temperature for the entire vehicle. H. Rear Window Defroster : Press to clear the rear window of thin ice and fog. The defroster turns off automatically after ten minutes or when the ignition is turned off. To manually turn off the defroster before ten minutes have passed, press the control again. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17