2011 Ford Expedition Owner Guide 1st Printing - Page 172

Seating and Safety Restraints Deactivating/activating the Belt-Minderா feature (if equipped) Read Steps 1 - 4 thoroughly before proceeding with the deactivation/activation programming procedure. Note: If you are using MyKey™, the Belt-Minder௡ cannot be disabled. Also, if the Belt-Minder௡ has been previously disabled, it will be re-enabled after the use of MyKey™. Refer to MyKey™ in the Locks and security chapter. The driver Belt-Minder௡ feature can be deactivated/activated by performing the following procedure: Before following the procedure, make sure that: • The parking brake is set • The gearshift is in P (Park) • The ignition switch is in the off position • The driver and passenger safety belts are unbuckled WARNING: While the design allows you to deactivate your Belt-Minder௡, this system is designed to improve your chances of being safely belted and surviving an accident. We recommend you leave the Belt-Minder௡ system activated for yourself and others who may use the vehicle. To reduce the risk of injury, do not deactivate/activate the Belt-Minder௡ feature while driving the vehicle. 1. Turn the ignition switch to the on position. DO NOT START THE ENGINE. 2. Wait until the safety belt warning light turns off (Approximately one minute). • Step 3 must be completed within 50 seconds after the safety belt warning light turns off. 3. Buckle then unbuckle the safety belt nine times at a moderate speed, ending in the unbuckled state. • After Step 3, the safety belt warning light will be turned on for three seconds. 4. Within approximately seven seconds of the light turning off, buckle then unbuckle the safety belt. • This will disable the Belt-Minder௡ feature for that seating position if it is currently enabled. As confirmation, the safety belt warning light will flash four times per second for three seconds. 172 2011 Expedition (exd) Owners Guide, 1st Printing USA (fus)