2012 Ford F150 Owner Guide 2nd Printing - Page 121

Driver Controls Programing the transmitters To program HomeLink௡ to the Genie IC2 transmitter you must first put the Genie IC2 transmitter into Intellicode 1 mode (IC1). To do this A. Red LED B. Green LED A B 1. Press and hold one of the Genie IC2 buttons on the transmitter for 10 seconds (the LED light will change from green to green and red). 2. Press the same button twice to confirm the change to Intellicode 1 mode. If done properly the LED light will appear red. After confirming that you have switched your Genie IC2 into IC1 mode, to continue programming 3. Hold both hand-held transmitters within 1-3 inches (2-8 cm) of one another. 4. Press and hold the both the programmed Genie button and the HomeLink௡ button you want to program at the same time. 5. The HomeLink௡ LED will flash rapidly when the programming is successful. Note: the Genie transmitter will transmit for 30 seconds. If HomeLink௡ does not program within 30 seconds the Genie transmitter will need to be pressed again, and steps 3-5 repeated. Note: If the Genie transmitter LED displays green and red release the button. Wait 3 seconds until the LED turns off before pressing the button. Once HomeLink௡ has been programmed successfully, the Genie IC2 transmitter will still be in IC1 mode and must be changed back. To return back to IC2 mode 1. Press and hold the previously programmed Genie button for 10 seconds. The LED will change from red to red and green. 2. Press the same button twice to confirm the change back to IC2 mode. If done correctly the LED will turn green. 121 2012 F-150 (f12) Owners Guide, 2nd Printing USA (fus)