2013 Ford F150 SuperCrew Cab Owner Manual Printing 3 - Page 68

Keys and Remote Control 67 Integrated Keyhead Transmitter 1. Twist a thin coin in the slot near the key 1 ring to remove the battery cover (1). 2. Carefully peel up the rubber gasket (2) 2 from the transmitter if it does not come off with the battery cover. 3 3. Remove the old battery (3). 4. Insert the new battery. Refer to the instructions inside the integrated keyhead transmitter for the correct orientation of the battery. Press the battery down to ensure that the battery is fully seated in the battery housing cavity. 5. Reinstall the rubber gasket. 6. Snap the battery cover back onto the key. Memory Feature (If Equipped) The feature allows the remote control to recall the driver seat, power mirrors, steering column (if equipped) and power adjustable foot pedals (if equipped) memory positions. Press the unlock button on the remote control to recall the memory positions. If the easy entry and exit feature is enabled, the seat will move to the easy entry position. The seat will move to the driver memory position when the key is put in the ignition. Programming Memory to the Transmitter 1. Move the memory features to the desired positions using the associated controls. 2. Press and hold memory button 1 (on the side of the driver's seat) for five seconds. A tone will sound after about 1 two seconds. Continue to hold until a second tone is heard. 3. Within three seconds press the lock button on the remote control. 4. Wait 10 seconds, then press the unlock button on the 2 remote control. Repeat this procedure for memory button 2 and a second remote control if desired. 2013 F-150 (f12) Owners Guide gf, 3rd Printing, February 2013 USA (fus)