2014 Ford F150 SuperCrew Cab Owner Manual Printing 1 - Page 129
2014 Ford F150 SuperCrew Cab Manual
Page 129 highlights
Universal Garage Door Opener (If Equipped) 2. The indicator light will begin to flash after 20 seconds. Without releasing the button, follow Step 1 in the Programming section. For questions or comments, contact HomeLink at www.homelink.com or 1-800-355-3515. E142658 3. Press and hold the function button you want to program for two seconds, then release. Repeat this step. Depending on your brand of garage door opener, you may need to repeat this sequence a third time. Erasing the Function Button Codes Note: You cannot erase individual buttons. Programming to a Genie Intellicode 2 Garage Door Opener Note: You must program the Genie Intellicode 2 transmitter to operate it with the garage door opener. Note: To program HomeLink to the transmitter, you must first put the transmitter into programming mode. A E142661 E142660 B Red indicator light Green indicator light A. B. 1. 1. Press and hold the outer two function buttons simultaneously for approximately 20 seconds until the indicator lights above the buttons flash rapidly. 2. When the indicator lights flash, release the buttons. You have erased the codes for all buttons. Reprogramming a Single Button To program a device to a previously trained button, follow these steps: 1. Press and hold the desired button. Do NOT release the button. Press and hold one of the buttons on the hand-held transmitter for 10 seconds. The indicator light will change from green to red and green. 2. Press the same button twice to confirm the change to programming mode. If done properly the indicator light will appear red. 3. Hold the transmitter within 1-3 inches (2-8 centimeters) of the button on the visor you want to program. 127 F150 (TF6)