2014 Ford Mustang Shelby GT500 Supplement Printing 1 - Page 38

Maintenance 5. Locate and carefully remove the engine oil level dipstick. 6. Wipe the dipstick clean. Insert the dipstick fully, then remove it again. • If the oil level is between the lower and upper holes, the oil level is acceptable. DO NOT ADD OIL. • If the oil level is below the lower hole, add enough oil to raise the level within the lower and upper holes. • The maximum oil level is between the upper hash mark and the upper hole. Oil levels above this range may cause engine damage. Some oil must be removed from the engine by an authorized dealer. 7. Put the dipstick back in and make sure it is fully seated. ENGINE AND INTERCOOLER COOLANT CHECK The concentration and level of engine coolant should be checked at the mileage intervals listed in the scheduled maintenance information. Note: Make sure that the level is between the MIN and MAX marks on the engine and intercooler coolant reservoirs. Note: Coolant expands when it is hot. The level may extend beyond the MAX mark. If the level is at the MIN mark, add coolant immediately. The coolant concentration should be maintained within 48% to 50%, which equates to a freeze point between -30°F (-34°C) and -34°F (-37°C). 37 2014 05+ Mustang (197) Supplement, 1st Printing, December 2012 USA (fus)