2015 Ford Taurus Owner Manual Printing 1 - Page 80
2015 Ford Taurus Manual
Page 80 highlights
Security 79 Programming a Spare Intelligent Access Key (If Equipped) Note: A maximum of four intelligent access keys can be programmed to your vehicle. You must take your vehicle and all access keys to your authorized dealer to be erased and reprogrammed if you would like to replace a previously programmed access key with a new access key, or if you already have four access keys programmed to your vehicle. You must have two previously programmed intelligent access keys inside your vehicle and the new unprogrammed intelligent access keys readily accessible. See your authorized dealer to have the spare key programmed if two previously programmed keys are not available. Make sure that your vehicle is off before beginning this procedure. Make sure that all doors are closed before beginning and that they remain closed throughout the procedure. Perform all steps within 30 seconds of starting the sequence. Stop and wait for at least one minute before starting again if any steps are performed out of sequence. Read and understand the entire procedure before you begin. 1. Place the new unprogrammed intelligent access key in the pocket inside of the center console with the buttons facing out and with key ring up. 2. Press the driver or passenger power door unlock control three times. 3. Press and release the brake pedal one time. 4. Press the driver or passenger power door lock control three times. 5. Press and release the brake pedal one time. The indicator on the START/STOP button should begin to rapidly flash, indicating the programming mode has been entered and two programmed intelligent access keys have been detected in your vehicle. 6. Press the START/STOP button within one minute. A message will appear in the information display indicating that the new intelligent access key was programmed. 7. Remove the intelligent access key from the center console pocket and press the unlock button on the newly programmed intelligent access key to exit programming mode. 8. Verify that the remote entry functions operate (press lock then unlock, making sure you end in unlock) and that your vehicle starts with new intelligent access key. 2015 Taurus Owners Guide gf, 1st Printing, April 2014 USA (fus)