1995 GMC Sonoma Owner's Manual - Page 125

Pushbuttons - The four pushbuttonslet you return to favorite stations.To set the pushbuttons for up to fourteen favorite stations(7 AM and 7 FM): 1 . Tune in the desired station. 2 . Push the SET button. "SET" appears in the display for about 5 seconds. 3. Within the 5 seconds, push one of the four pushbuttons. Whenever you press that button, the preset station will return. NOTE: In addition to the four stations set as above, up to three additional stations may be preset on each band by pressing two adjoiningpushbuttons at the same time, Then do the following: 1. Tune in the desired station. 2. Press the SET button. 3. Within 5 seconds, press any two adjoining pushbuttons at the same time. (The station will return when the same two buttons are pressed again.) Adjust the Tone - Use the levers in the upper middle left corner to set the bass, midrange, and treble until you get the sound you want. The 60 and 250 levers adjust the bass, I K is midrange, and 3.5K and 1 OK control the treble. We suggest you start with the center lever ( I K) in the midpoint position, then move the others up until you get the amount of bass and treble you like. Am-St Button - The Am-St button is just below the SEARCH button. Push this when you tune to an AM station that broadcasts in stereo. Your STEREO light will come on when you're receiving AM stereo. If you push Am-St and there is no more noise, it means the station is weak. You'll hear the station better if you don't use Am-St. Just push the Am-St button again to delete stereo. AUTO DNR@- This unit is equipped with an automatic Dynamic Noise Reduction system. DNR'reduces background hiss on AM and FM radio broadcasts, as well as on cassette tapes. DNR'is a registered trademark of National Semiconductor Corporation. To Play A Cassette Your tape player is built to work best with tapes that are 30 to 45 minutes long on each side. Tapes longer than that are so thin they may not work well in this player. Once the tape is playing, use the upper and lower knobs forvolume, balance and fade justas you do for the radio. A lighted arrow shows which direction the tape is being played. Cr02 - The Cr02button lets you set the system for the type of cassette being used. If you are using chrome or metal tapes. push the Cr02 button in. 3-11