2001 GMC Jimmy Owner's Manual - Page 347

Two-Piece Front Turn Signal Lamp Assembly 1. Remove the headlamp assembly as shown under "Two-Piece Composite Headlamp System" earlier in this section. 2. Locate the locking tabs on the assembly. Squeeze the tabs together and push that end of the assembly out while holding the tabs. The assembly will swing out. 4. Turn the harness bulb socket counterclockwise to remove it. 5. Pull the bulb straight out to remove it from the socket. 6. Push the new bulb into the socket until it snaps into place. 3. Unplug the electrical connector. 7. Reinstall the harness bulb socket with the new bulb into the headlamp assembly and turn it clockwise until it is tight. 8. To reinstall the assembly, snap the outboard end of the lamp assembly back into the vehicle. Then swing the assembly in and snap it into place. 9. Install the two retaining clips. 6-40