2011 GMC Savana 2500 Passenger Owner's Manual - Page 164

6-2 Lighting 2 (Headlamps): ... Turns on the headlamps together with the following lamps listed below. Parking Lamps Instrument Panel Lights Taillamps License Plate Lamps Exterior Lamps Off Reminder If a door is open, a reminder chime sounds when the headlamps or parking lamps are manually turned on and the key is out of the ignition. To turn off the chime, turn the headlamp switch to O or AUTO and then back on, or close and re‐open the door. In the auto mode, the headlamps turn off once the ignition is in LOCK/OFF or may remain on until the headlamp delay ends, if enabled in the Driver Information Center (DIC). See "Exit Lighting" under Vehicle Personalization on page 5‑40. This instrument panel cluster light comes on when the high beam headlamps are on. If the headlamps are turned on while the vehicle is on, the headlamps turn off automatically 10 minutes after the ignition is turned off. If the headlamps are turned on while the vehicle is off, the headlamps will continue to stay on. To prevent the battery from being drained, turn the control to the O position. A warning chime sounds if the driver door is opened while the ignition switch is off and the headlamps are on. To change the headlamps from low beam to high beam, push the turn signal/multifunction lever toward the instrument panel. Flash-to-Pass This feature is used to signal to the vehicle ahead that you want to pass. If the headlamps are off or in the low‐beam position, pull the turn signal lever toward you to momentarily switch to high‐beams. Release the lever to turn the high-beam headlamps off. Headlamp High/ Low-Beam Changer 2 3 (Headlamp High/Low‐Beam Changer): Pull the turn signal lever all the way toward you to change the headlamps from low to high beam. Then release it.