1995 Honda Accord Owner's Manual - Page 26

Child Safety To install a locking clip, do the following: 1. Place the child restraint in the desired position. Route the lap/ shoulder belt through the restraint according to the seat manufacturer's instructions. 2. Insert the latch plate into the buckle. Pull on the shoulder part of the belt to make sure there is no slack in the lap portion. 3. Tightly grasp the belt near the latch plate. Pinch both parts of the belt together so they won't slip through the latch plate. Unbuckle the seat belt. 4. Install the locking clip as shown. Position the clip as close as possible to the latch plate. 5. Insert the latch plate into the buckle. Push and pull on the child seat to verify that it is held firmly in place. If it is not, repeat these steps until the restraint is secure. 340 mm (13.4 in) Using Child Restraints with Tethers 121 m m (4.8 in) 306 m m (12.0 in) Your Honda has three attachment points for tether-style child seat. They are located on the rear shelf. U.S. Models Use the dimensions in the illustration to locate either of the outside attachment points you want to use. Cut a 22 mm (7/8 inch) diameter hole in the rear shelf. CONTINUED Driver and Passenger Safety