1997 Honda Prelude Owner's Manual - Page 152

Cooling System RESERVE TANK RESERVE TANK CAP DRAIN BOLT Except Type SH only Apply non-hardening sealant to the drain bolt threads, put a new washer on the drain bolt, and reinstall the bolt in the engine block. Tighten it securely. Tightening torque: 61 lbf.ft(8.5 kgf.m , 83 N.m) 6. Mix the recommended antifreeze with an equal amount of purified or distilled water in a clean container. The cooling system capacity is: With 5-speed manual transmission: Except Type SH DRAIN PLUG HOLDER Except Type SH only Remove the drain bolt and washer from the engine block. 4. Remove the reserve tank from its holder by pulling it straight up. Drain the coolant, then put the tank back in its holder. 5. When the coolant stops draining, tighten the drain plug in the bottom of the radiator. (Except Type SH) 0.87 US gal (3.3 , 0.73 Imp gal) (Type SH) 0.85 US gal (3.2 , 0.70 Imp gal) With automatic transmission: 0.85 US gal (3.2 , 0.70 Imp gal) CONTINUED Maintenance