1998 Honda Civic Owner's Manual - Page 191
1998 Honda Civic Manual
Page 191 highlights
Lights 4. Unclip the end of the hold-down wire from its slot. Pivot it out of the way and remove the bulb. 5. Insert the new bulb into the hole, making sure the tabs are in their slots. Pivot the hold-down wire back in place and clip the end into the slot. HOLD-DOWN WIRE HOLDER WEATHER SEAL BULB CONNECTOR 1. Open the hood. If you need to change the headlight bulb on the driver's side, remove the power steering reservoir tank by pulling it out of its holder. 2. Remove the electrical connector from the bulb by squeezing the connector on both sides to unlock the tab. Pull the connector straight off. 3. Remove the rubber weather seal by pulling on the tab. 6. Install the rubber seal over the back of the headlight assembly. Make sure it is right side up; it is marked ''TOP". 7. Push the electrical connector onto the tabs of the new bulb. Make sure it locks in place. Turn on the headlights to test the new bulb. 8. (Driver's side) Reinstall the power steering reservoir. Maintenance