1999 Honda Civic Owner's Manual - Page 204

Lights 4. Unclip the end of the hold-down wire from its slot. Pivot it out of the way and remove the bulb. 5. Insert the new bulb into the hole, making sure the tabs are in their slots. Pivot the hold-down wire back in place and clip the end into the slot. 6. Install the rubber seal over the back of the headlight assembly. Make sure it is right side up; it is marked "TOP." 7. Push the electrical connector onto the tabs of the new bulb. Make sure it locks in place. Turn on the headlights to test the new bulb. 8. (Driver's side) Reinstall the power steering reservoir. 1. If you are changing the bulb on the driver's side, start the engine, turn the steering wheel all the way to the right, and turn off the engine. If you are changing the bulb on the passenger's side, turn the steering wheel to the left. 2. Use a flat-tipped screwdriver to remove the holding clip from the inner fender. 3. Pull the inner fender cover back. 4. Remove the socket from the headlight assembly by turning it one-quarter turn counterclockwise. CONTINUED Replacing the Front Side Marker/ Turn Signal and Parking Light Bulb HOLDING CLIP Maintenance