2001 Honda Accord Owner's Manual - Page 88
2001 Honda Accord Manual
Page 88 highlights
HomeLink Universal Transmitter Retraining a Button To train an already programmed transmitter button to operate a new device: 5. Release both buttons. The transmitter should now be trained to operate the device. Erasing Codes To erase the codes stored in all three buttons, press and hold the two outside buttons until the red light begins to flash, then release the buttons. 1. Select the transmitter button you want to train. 2. Press and hold the transmitter button until the red light begins to flash slowly (approximately 20 seconds). 3. While continuing to hold the transmitter button, place the remote control for the device 2 to 5 inches from the HomeLink transmitter. 4. Press and hold the button on the remote control. Hold both buttons until the red light begins to flash rapidly. As required by the FCC: This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Industry Canada Standard RSS-210. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference that may cause undesired operation of the device. You should erase all three codes before selling the car. Instruments and Controls