2013 Honda Pilot Owner's Manual - Page 403
2013 Honda Pilot Manual
Page 403 highlights
Replacing Light Bulbs QRG Headlight Bulbs When replacing, use the following bulbs. High beam headlight: Low beam headlight: 60W (HB3) 55 W (H11) 1 Headlight Bulbs NOTICE ■ High Beam Headlight Driver's side Halogen bulbs get very hot when lit. Oil, perspiration, or a scratch on the glass can cause the bulb to overheat and shatter. The headlight aim is set by the factory, and does not need to be adjusted. However, if you regularly carry heavy items in the cargo area or tow a trailer, have the aiming readjusted at a dealer or by a qualified technician. The HB3 and H11 types are halogen bulbs. When replacing a bulb, handle it by its base, and protect the glass from contact with your skin or hard objects. If you touch the glass, clean it with denatured alcohol and a clean cloth. The exterior lights' inside lenses (headlights, brake lights, etc.) may fog temporarily after a car wash or while driving in the rain. This does not impact the exterior light function. However, if you see a large amount of water or ice accumulated inside the lenses, have your vehicle inspected by a dealer. Bulb 1. Remove the clips using a flat-tip screwdriver, then remove the upper part of the air intake duct. 2 Engine Compartment Covers P. 391 Coupler Driver and passenger side 2. Push the tab to remove the coupler. 3. Rotate the old bulb to the left to remove. 4. Insert a new bulb into the headlight assembly and turn it to the right. 5. Insert the coupler into the connector of the bulb. Tab TOC Maintenance Index Home 402