2003 Hummer H2 Owner's Manual - Page 11

Easy Exit Seat This feature makes entering or leaving the driver's seat easier. (Exit): This button is used to program and recall the desired driver's seat exit/entry position. The seat position can be personalized for driver 1 and driver 2. To store the seat exit position for driver 1 or driver 2, do the following: 1. Select the desired driver number by pressing the 1 or 2 button. The seat will move to the last stored memory position. 2. Adjust the seat to the desired exit/entry position. 3. Press and hold the the exit button for three seconds. A double chime will sound to let you know the exit position has been stored for the identified driver (driver 1 or 2). To use the exit/entry feature, do one of the following: D Press the exit button on the memory control. D Or, if you have this feature enabled (active) in the DIC, then removing the key from the ignition will cause the seat to move to the exit/entry position. See "Driver Information Center" in the Index. Heated Front Seats (If Equipped) The buttons for the driver's side heated seat are located on the driver's side door panel. The buttons for the passenger's side heated seat are located on the passenger's side door panel. The engine must be running for this feature to operate. To heat the entire seat, press the horizontal button with the heated seat symbol. Press the button to cycle through the temperature settings of high, medium and low and to turn the seat off. The indicator lights will glow to indicate the level of heat selected: three for high, two for medium and one for low. The low setting warms the seatback and seat cushion until the seat temperature is near body temperature. The medium and high heat the seatback and seat cushion to a slightly higher temperature. You will be able to feel heat in about two minutes. 1-5