2008 Hummer H3 Alpha Owner's Manual - Page 187
2008 Hummer H3 Alpha Manual
Page 187 highlights
Finding a Category (CAT) Station (XM™ Satellite Radio Service Only) To select and find a desired category perform the following: 1. Press the CAT button to activate program type select mode. A category displays. 2. Press the CAT button to select a category. If the radio cannot find the desired program type, NONE or NOT FOUND displays and the radio returns to the last station you were listening to. BAND (Alternate Frequency) (Radio with Single CD): Alternate frequency allows the radio to switch to a stronger station with the same category. To turn alternate frequency on, press and hold BAND for two seconds. AF ON displays. The radio can switch to stations with a stronger frequency. To turn alternate frequency off, press and hold BAND again for two seconds. AF OFF displays. The radio does not switch to other stations. This function does not apply for XM™ Satellite Radio Service. • For the Radio with Six-Disc CD Player, turn the e knob to select a category. 3. Once the desired category is displayed, press either SEEK arrow to select and to take you to the categories first station. 4. To go to another station within that category and the category is displayed, press the CAT button once. If the category is not displayed, press the CAT button twice to display the category and then to go to another station. Radio Messages CAL ERR (Calibration Error): The audio system has been calibrated for your vehicle from the factory. If CAL ERR displays it means that the radio has not been configured properly for your vehicle and it must be returned to your dealer/retailer for service. LOC (Locked): This message is displayed when the THEFTLOCK® system has locked up. Take your vehicle to your dealer/retailer for service. If any error occurs repeatedly or if an error cannot be corrected, contact your dealer/retailer. 3-53 • For the Radio with Six-Disc CD Player, press either SEEK arrow to go to another station within that category and the category is displayed. 5. Press CAT to exit program type select mode. If CAT times out and is no longer on the display, go back to Step 1.