2007 Infiniti FX45 Owner's Manual - Page 148
2007 Infiniti FX45 Manual
Page 148 highlights
4. Push the SET switch and, within 5 seconds, push the memory switch (1 or 2) fully for at least 1 second. The indicator light for the pushed memory switch will come on and stay on for approximately 5 seconds after pushing the switch. After the indicator light goes off, the selected positions are stored in the selected memory (1 or 2). If a new memory is stored in the same memory switch, the previous memory will be deleted. SPA2185 With the key removed from the ignition button on the switch, press the keyfob or Intelligent Key. The driver's seat, steering wheel and outside mirrors will move to the memorized position. Confirming memory storage Turn the ignition ON and push the SET switch. If the main memory has not been stored, the indicator light will come on for approximately 0.5 seconds. When the memory has stored the position, the indicator light will stay on for approximately 5 seconds. If the battery cable is disconnected, or if the fuse opens, the memory will be canceled. In such a case, reset the desired positions using the following procedures. 1. Open and close the driver's door more than two times with the ignition key in the LOCK position. 2. Reset the desired position using the previous procedure. 1. Apply the parking brake, and set the selector lever to the P (Park) position. 2. Turn the ignition ON. 3. Adjust the driver's seat, steering column and outside mirrors to the desired positions by manually operating each adjusting switch. For additional information, see "Seats" in the "1. Safety - Seats, seat belts and supplemental restraint system" section and "Steering wheel" and "Outside mirrors" earlier in this section. During this step, do not turn the ignition to any positions other than ON. Linking a keyfob or Intelligent Key to a stored memory position A keyfob or Intelligent Key can be linked to a stored memory position with the following procedure. 1. Follow the steps for storing a memory position. 2. While the indicator light for the memory switch being set is illuminated for 5 seconds, press the button on the keyfob or Intelligent Key. The indicator light will blink. After the indicator light goes off, the keyfob or Intelligent Key is linked to that memory setting. Selecting the memorized position 1. Set the selector lever to the P (Park) position. 3-32 Pre-driving checks and adjustments