2009 Jeep Commander Owner Manual - Page 30
2009 Jeep Commander Manual
Page 30 highlights
28 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE • The engine can be started two consecutive times (two 15 minute cycles) with the RKE transmitter. However, the ignition must be cycled by pushing the START/ STOP button twice (or the ignition switch must be cycled to the ON position) before you can repeat the start sequence for a third cycle. To Exit Remote Start Mode Without Driving the Vehicle Allow the engine to run for the entire 15 minute cycle. To Exit Remote Start Mode and Drive the Vehicle Before the end of 15 minute cycle, press and release the UNLOCK button on the RKE transmitter to unlock the doors and disarm the Vehicle Security Alarm (if equipped). Then, prior to the end of the 15 minute cycle, simply press and release the START/STOP button. If the START/STOP button is not present, insert the key into the ignition switch and turn the switch to the ON position. NOTE: • For the vehicle not equipped with Keyless Go feature, the ignition switch must be in the ON position in order to drive the vehicle. • For the vehicle not equipped with Keyless Go feature, the message "Insert Key/Turn To On" will display in the EVIC until you insert the key. Once inserted, the message "Turn To On" will display in the EVIC until you turn the key to On. Refer to "Electronic Vehicle Information Center (EVIC)" in Section 4 of this manual. • For the vehicle equipped with Keyless Go feature, the message "Push Button/Insert Key" will display in the EVIC until you push the START Button.