2009 Jeep Liberty Quick Reference Guide - Page 5
2009 Jeep Liberty Manual
Page 5 highlights
v ehi c le fe at u r e s Fuel Cap: Loose Gas Cap Message • If a "gas cap" message (shown as gASCAP or CHECK GASCAP) appears, tighten the gas cap until a "clicking" sound is heard. • Press the odometer reset button to turn the message off. • If the message continues to appear for more than three days after tightening the gas cap, see your dealer. Rotate Blower Control Rotate Temp. Control Rotate Mode Control Tire Pressure Monitoring System (TPMS): • If one or more of the four road tire pressures are low, the Tire Pressure Monitoring Light will illuminate and an audible chime will sound. • Check the inflation pressure of each road tire on your vehicle and inflate to the recommended cold pressure value, shown on the placard located in the driver's door opening. The TPMS light should not be used as a tire pressure gauge when adjusting your tire pressure. • The light will turn off once the updated tire pressure has been recognized. The vehicle may need to be driven for up to 20 minutes above 15 mph (25 km/h) before the light will turn off. Temperature changes can affect tire pressures, causing the TPMS light • to turn on. Colder temperatures will decrease tire pressure and warmer temperatures will increase tire pressure. • If your spare tire's pressure is low or in use on the vehicle, the TPMS light may turn on. Refer to your Owner's Manual. Push Air Recirc. Button Push A/C Button Push Rear Window Defroster Button Manual Climate Controls: Air Recirculation • Use recirculation for maximum A/C operation. • For window defogging, turn recirculation off. • Recirculation is not allowed in defrost, floor, defrost/floor (mix) modes. Driver Power Seat: • This switch, located on the outboard side of the seat, controls the forward/ backward and up/down movement of the seat. Driver memory Seat: • The memory seat feature allows you to save two different driver seating positions. With the key in the ON/RUN position, push , S then 1 or 2 within five seconds. • Push 1 or 2 to recall the saved positions. • Key fobs may be programmed to automatically recall position 1 or 2 when UNLOCK is pushed. • Refer to Owner's Manual for programming instructions. Oil Change Indicator: Message • If an "oil change" message (shown as CHAngE Oil or Oil Change Required) appears and a single chime sounds, it is time for your next required oil change. Resetting Light After Servicing • Turn the ignition switch to the ON/RUN position (do not start engine). • Fully depress the accelerator pedal three times within 10 seconds. • Turn the ignition switch to the OFF/LOCK position.