2010 Jeep Compass User Guide - Page 18

GETTING STARTED • Language • Auto Door Locks • Auto Unlock On Exit • Sound Horn With Remote Key Lock • Illuminated Approach • Headlamp Off Delay • RKE Unlock (Remote Key Unlock) Driver's Door 1st • Key-Off Power Delay • Display Units of Measure In • Confirmation of Voice Commands • Automatic Compass Calibration • Compass Variance • Manual Compass Calibration • Flash Lamps With Lock (Flashing Lights with Remote Key Lock) Key Fob Programmable Features • The following features may also be programmed using the Key Fob transmitter or the ignition switch and driver's door lock switch. NOTE: Pressing the LOCK button while you are inside the vehicle will activate the Vehicle Security Alarm. Opening a door with the Vehicle Security Alarm activated will cause the alarm to sound. Press the UNLOCK button to deactivate the Vehicle Security Alarm. Unlock On First Press • To unlock either the driver's side, or all doors, on the first press of the UNLOCK button: • Press and hold the LOCK button for at least 4 seconds, but no longer than 10 seconds. Then, press and hold the UNLOCK button while still holding the LOCK button. • Release both buttons at the same time. Auto Unlock Doors On Exit • To have all of the vehicle doors unlock when any door is opened: • Enter your vehicle and close all the doors. • Within 15 seconds, cycle the ignition switch from the LOCK position to the ON position a minimum of four times, ending in the LOCK position (do not start the engine). • Within 30 seconds, press the driver's door lock switch in the UNLOCK direction. A single chime will indicate that programming is complete. Auto Door Lock • To have the doors lock automatically when the vehicle's speed exceeds 15 mph (24 km/h): • Enter your vehicle and close all the doors. • Within 15 seconds, cycle the ignition switch from the LOCK position to the ON position a minimum of four times, ending in the LOCK position (do not start the engine). • Within 30 seconds, press the driver's door lock switch in the LOCK direction. A single chime will indicate that programming is complete. 16