2010 Jeep Patriot Owner's Manual - Page 160

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 159 6. Firmly press and release the LEARN or TRAINING Gate Operator/Canadian Programming button. The name and color of the button may vary by Canadian radio-frequency laws require transmitter signals to "time-out" (or quit) after several seconds of manufacturer. transmission - which may not be long enough for NOTE: You have 30 seconds in which to initiate the next HomeLink to pick up the signal during programming. step after the LEARN button has been pressed. Similar to this Canadian law, some U.S. gate operators are 7. Return to the vehicle and press the programmed designed to "time-out" in the same manner. HomeLink button twice (holding the button for two It may be helpful to unplug the device during the cycling seconds each time). If the device is plugged in and process to prevent possible overheating of the garage activates, programming is complete. door or gate motor. If the device does not activate, press the button a third If you are having difficulties programming a garage door time (for two seconds) to complete the training. opener or a gate operator, replace "Programming If you have any problems, or require assistance, please HomeLink " Step 3 with the following: call toll-free 1-800-355-3515 or, on the Internet at 3. Continue to press and hold the HomeLink button, www.HomeLink.com for information or assistance. while you press and release ("cycle"), your handheld To program the remaining two HomeLink buttons, transmitter every two seconds until HomeLink has sucrepeat each step for each remaining button. DO NOT cessfully accepted the frequency signal. The indicator light will flash slowly and then rapidly when fully trained. erase the channels. 3