2011 Jeep Wrangler User Guide - Page 51

OFF-ROAD CAPABILITIES COMMAND-TRAC®/ ROCK-TRAC® will start regardless of whether or not the clutch pedal is depressed. AXLE LOCK (TRU-LOK®) RUBICON ONLY • The AXLE LOCK switch is located on the instrument panel (to the left of the steering column). • This feature will only activate when the following conditions are met: • Key in ignition, vehicle in 4L (Low) range. • Vehicle speed at 10 mph (16 km/h) or less. • Press the bottom of the AXLE LOCK switch once to lock the rear axle only and a second time to lock the front axle (the rear and front axle lock indicator lights will illuminate). • To unlock the axles, press the top of the AXLE LOCK switch. • The indicator light will flash until the axles are fully locked or unlocked. • The transfer case provides four mode positions: 2H (Two-wheel drive high range), 4H (Four-wheel drive high range), N (Neutral), and 4L (Four-wheel drive low range). • The transfer case is intended to be driven in the 2H position for normal street and highway conditions such as hard-surfaced roads. • Shifting between 2H and 4H can be made with the vehicle stopped or in motion. Shift the transfer case lever firmly to 4H at any speed up to 50 mph (80 km/h). • Shifting between 4H and 4L can be made with the vehicle rolling at 2 to 3 mph (3 to 5 km/h). Shift the automatic transmission into NEUTRAL or fully depress the clutch pedal on a manual transmission. Shift the transfer case lever firmly to 4L (do not pause with the transfer case in NEUTRAL). Once the shift is completed, place the automatic transmission into DRIVE or release the clutch pedal on a manual transmission. NOTE: To enhance off-road performance in 4L mode, manual transmission vehicles ELECTRONIC SWAY BAR DISCONNECT - RUBICON ONLY Off-Road • Press the SWAY BAR switch, located on the instrument panel (to the left of the steering column), once to disconnect the Sway Bar. • The Sway Bar indicator light will illuminate in the instrument cluster. On-Road • Press the SWAY BAR switch a second time to reconnect the Sway Bar. • The Sway Bar should remain in on-road mode during normal driving conditions. 49