2012 Jeep Wrangler Owner Manual Supplement - Page 22

20 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE The BeltAlert௡ warning sequence begins within 60 seconds of the vehicle speed over 5 mph (8 km/h), by blinking the Seat Belt Reminder Light and sounding an intermittent chime. Once the sequence starts, it will continue for 96 seconds or until the respective seatbelts are fastened. After the sequence completes, the Seatbelt Reminder Light remains illuminated until the respective seatbelts are fastened. The driver should instruct all other occupants to fasten their seatbelts. If a front seatbelt is unbuckled while traveling at speeds greater than 5 mph (8 km/h), BeltAlert௡ will chime once and illuminate the Seat Belt Reminder Light, then will proceed to the 96 second warning sequence. the rear seat in pet harnesses or pet carriers that are secured by seat belts, and cargo is properly stowed. BeltAlert௡ can be enabled or disabled by your authorized dealer or by following these steps: NOTE: The following steps must occur within the first 60 seconds of the ignition switch being turned to the ON/RUN or START position. Chrysler Group LLC does not recommend deactivating BeltAlert௡. 1. Turn the ignition switch to the OFF position, and buckle the driver's seat belt. 2. Turn the ignition switch to the ON/RUN position (do not start the engine), and wait for the Seat Belt Reminder The front passenger seat BeltAlert௡ is not active when the Light to turn off. front passenger seat is unoccupied. BeltAlert௡ may be triggered when an animal or heavy object is on the front 3. Within 60 seconds of starting the vehicle, unbuckle passenger seat or when the seat is folded flat (if and then re-buckle the driver's seat belt at least three equipped). It is recommended that pets be restrained in times within 10 seconds, ending with the seat belt buckled.