2015 Jeep Wrangler Owner Manual - Page 316

314 UNDERSTANDING YOUR INSTRUMENT PANEL U.S. Federal regulations require that upon transfer of vehicle ownership, the seller certify to the purchaser the correct mileage that the vehicle has been driven. If your odometer needs to be repaired or serviced, the repair technician should leave the odometer reading the same as it was before the repair or service. If s/he cannot do so, then the odometer must be set at zero, and a sticker must be placed in the door jamb stating what the mileage was before the repair or service. It is a good idea for you to make a record of the odometer reading before the repair/ service, so that you can be sure that it is properly reset, or that the door jamb sticker is accurate if the odometer must be reset at zero. Vehicle Odometer Messages gATE ...Swing Gate Ajar LoW tirE ...Low Tire Pressure HOTOIL ...Transmission Oil Temperature Above Normal Limits gASCAP ...Fuel Cap Fault noFUSE ...Fuse Fault CHAngE OIL ...Oil Change Required NOTE: If the vehicle is equipped with the optional Electronic Vehicle Information Center (EVIC) in the instrument cluster, all the messages will only be displayed in the EVIC display. For additional information, refer to "Electronic Vehicle Information Center - If Equipped." ECO (Fuel Saver Indicator) - If Equipped The ECO indicator will illuminate when you are driving When the appropriate conditions exist, the following in a fuel efficient manner and can be used to modify odometer messages will display: driving habits in order to increase fuel economy. ECO ...Fuel Saver Indicator door ...Door Ajar