2008 Kawasaki Brute Force 650 4x4 Realtree Hardwoods Green HD Owners Manual - Page 42
2008 Kawasaki Brute Force 650 4x4 Realtree Hardwoods Green HD Manual
Page 42 highlights
40 GENERAL INFORMATION Oil Pressure Warning Symbol: The "LED" (Light Emitting Diode) oil pressure symbol flashes to warn the operator whenever the oil pressure is dangerously low or the ignition key is in the "ON" position with the engine not running, and goes off when the engine oil pressure is high enough. Refer to the MAINTENANCE AND ADJUSTMENT chapter for more detailed engine oil information. Belt Check Indicator Light: This vehicle is equipped with a drive belt failure detection system. Excessive belt wear or belt damage will activate a switch in the transmission cover causing the belt indicator light to flash at intervals of 0.35 seconds. The indicator also serves as an hour meter to indicate when periodic maintenance should be performed. The indicator turns on when the vehicle has been used for a total of 100 hours of operation. When the belt indicator light goes on, return the vehicle to the dealer immediately for inspections, adjustment, and/or repairs as necessary. Refer to the "Belt Drive Transmission" section on the "Maintenance and Adjustment" chapter. j NOTICE The Belt Check Indicator Light comes on after 100 hours of operation as a reminder that the drive belt must be inspected for wear. żWhen the lead connector for the drive belt indi- NOTE cator is disconnected or the lead itself is cut and broken, while the main switch is on, the indicator light also starts flashing. In this case as well, you need to return the vehicle to the dealer for reset and adjustment.