1999 Lexus GS 400 Owners Manual - Page 109
1999 Lexus GS 400 Manual
Page 109 highlights
INTERIOR EQUIPMENT " 1 Buttons 2 Indicator light programming HomeLinkR. 1. Locate the "training" or "learning" button on the in-garage receiver and push and release this button. Location of the button may vary by the garage door opener manufacturer. 2. Firmly push and release the trained HomeLinkR button 2 times (some garage door manufacturer may require you to push the HomeLinkR button up to 3 times) to complete the process. The garage door should now operate when the HomeLinkR button is pushed. The HomeLink R has 3 buttons and can be programmed to operate 3 separate devices. Prepare the HomeLink R for programming by erasing all codes or the memorized data programmed by the former owner. Follow the procedure in "(c) Erasing the garage door opener memory". 1. Decide which one of the 3 buttons you want to program. Push and hold down the button for about 20 seconds until the indicator light begins to flash. While holding this button, follow steps "2" and "3". 2. Bring the hand held garage door opener within about 25 mm (1 in.) of the button being programmed and push the button on the hand held garage door opener. The signal from the hand held garage door opener is sent to the vehicle's opener. 3. When the frequency and code is registered, the indicator light flashes rapidly. At this point, you can release both buttons. 4. To program the remaining buttons, repeat steps "1" through "3". If you want to replace an existing program with a new program, select the button you want to program. Follow the procedure from step 1. If the transmitter has a "rolling code feature", it is necessary to program the in-garage receiver after 89